Turbo Ace 61316 (HP06) BL Motor Replaced by 51416 (HP05): Brushless Outrunner Motor for Walkera CB100 & 4#3B, New Version

<< Previous in Brushless 1-S

Next in Brushless 1-S >>

Price: $37.95

Part Number: MT-61316 + Screws

Manufacturer Part No: 61300B9

Quantity:

Email this page to a friend

Newest version: Not all HP06 are created equal !

This is the newest version Turbo Ace 61300 (HP06) for the CB100 & 4#3B with no startup cogging problem running on stock Walkera ESC. This motor has been tested on the CB100 and 4#3B and has the best power/weight ratio. A light weight CB100/4#3B helicopter with this motor will be more agile even with just a couple of grams saving compared to the HP08. HP series of motors are known for high precision quality which translates to smooth operation and easy startups with no hand cranking required.

For the outrunner motor to start smoothly, you can also solder the 3 motor wires directly to the ESC. It is important to remove and discard the ESC wires and connector so that the wiring length is at the minimal. You must discard the wires and the connector from the ESC side and not use them. If the motor turns in the wrong direction just desolder any 2 wires, swap them and solder them back to the ESC. If you own a 4#3B or CB100 it is an option to swap the ESC with the 4#6/4G6 ESC since Turbo Ace and other outrunner motos starts better with 4#3B, CB100 ESC which have different timing for the outrunners.

Warning! Installing pinion on micro motor requires special technique and care otherwise the shaft can easily bent or the pinion skewed. Wow Hobbies has already installed the pinion for you on this motor to avoid the risk of permenent motor shaft damage.

High performance HP06, HP08 or Turbo Ace 31714 motors requires high discharge rate 20C batteries. For a selection of these batteries go to

http://www.wowhobbies.com/batteries.aspx

.
Motor type: Outrunner

Operating temperature: 95F compare to 120F on the Walker stock BL motor

Kv: 13,000

Weight: including wires- without connector: 5.8g

ESC Compatibility: When the motor wires are soldered directly to the ESC, the motor will startup with 99% of the Walkera CB100/4#3B ESC. If you use the connector, the motor will startup with about 90% of the Walker CB100/4#3B ESC. If you order the http://www.wowhobbies.com/sale1299xp-7aebayblesc-2.aspx you can use plug and will start the motor easily.

Pinion: 16T pinion installed

3 pin Walkera motor connector: not included

Motor screws: included