Turbo Ace 31714 Brushless Motor: 25-30% More Torque Than Stock, 14T Brass Pinion Installed, for Walkera 4G6S/4G6/4#6(S),V120D01/02 & Nouvs 125 CP

The Turbo Ace Power House 31714 inrunner motor. This is a direct drop in plug-and-play inrunner motor for the 4G6S, 4G6 and the Novus 125 CP. It generates an additional 400 RPM from stock motor both running at 100% throttle. It is 3mm taller than stock, height is at 25mm verses stock at 22mm. When flying with stock radio setup, no adjustment is needed. Throttle curve can be increased to 100% and the motor still runs much cooler than Walkera stock inrunner motor. This motor totally eliminates the motor burn out problem found on the stock 4G6 and its does not require soldering like the outrunners. The motor needs the stock 10A Walkera ESC to properly fuel its amperage requirement, XP7A-2 rated at 7A will not be adequate to properly power this motor. The motor runs extremely efficient with lower temperature and achieve the same flight time as the Walkera stock. It does not need a direct soldered connection from the motor to the Walkera ESC, just tighten the screws and plug it in and you are ready for the extreme maneuvers of your time.

Operating temperature: Normal flight 120 degrees vs. 130 degrees on stock Walkera BL motor. Full 3D flight 129 degrees vs. over 150 degrees for stock Walkera motor. Turbo Ace and other high performance motors run the coolest with 4#3B, CB100 ESC which have more suitable timing. It is not a bad idea to swap your CB100/4#3B ESC with your 4G6S/4G6/4#6S/4#6/Heli-Max 125 CP/FP ESC to obtain even better result with this motor.