Browse Categories
Browse by Manufacturer
Search

Mailing Lists
Sign up to stay in touch
sign up to get interesting news and updates delivered to your inbox

WOW-MT-31714-4G6:TurboAce31714 Brushless Motor:14T Brass Pinion Installed on a Power House Inrunner Motor for V120D03&4G3,Pinion is not spaced for 4G6

<< Previous in Brushless Motors Next in Brushless Motors >>

Price: $34.95
Out of stock
Part Number: WOW-MT-31714-4G6-4#6
Manufacturer: WOW
Manufacturer Part No: WOW-MT-31714-4G6-4#6
The Turbo Ace Power House 31714 inrunner motor. This is a direct drop in plug-and-play inrunner motor for the V100D03 & 4G3. It generates an additional 400 RPM from stock motor both running at 100% throttle. It is 3mm taller than stock, height is at 25mm verses stock at 22mm. When flying with stock radio setup, no adjustment is needed. Throttle curve can be increased to 100% and the motor still runs much cooler than Walkera stock inrunner motor. This motor totally eliminates the motor burn out problem found on the stock 4G6 and its does not require soldering like the outrunners. The motor needs the stock 10A Walkera ESC to properly fuel its amperage requirement, XP7A-2 rated at 7A will not be adequate to properly power this motor. The motor runs extremely efficient with lower temperature and achieve the same flight time as the Walkera stock. It does not need a direct soldered connection from the motor to the Walkera ESC, just tighten the screws and plug it in and you are ready for the extreme maneuvers of your time.
 
High performance HP06, HP08 or Turbo Ace 31714 motors requires high discharge rate 20C batteries. For a selection of these batteries go to

Motor type: Inrunner

Operating temperature: Normal flight 120 degrees vs. 130 degrees on stock Walkera BL motor. Full 3D flight 129 degrees vs. over 150 degrees for stock Walkera motor.
Kv: 16,800
Dimension: 25mmx12mm
Weight: including wires- without connector: 12.9g. Weight: including wires- with connector: 13.3g
ESC Requirement and Compatibility: Requires minimum of 8A. It is fully compatible with the Walker ESC without any cogging issues
Pinion: Walker compatible 14 teeth pinion fully installed and balanced
Motor screws: Not included but compatible with the Walkera stock motor screws