HM-CB100-Z-28-Version2(Tested) Walkera RX2436: Brushless Receiver for Walkera CB100 with the latest new tail ESC HM-CB100-Z-27

<< Previous in Walkera CB100 Parts

Next in Walkera CB100 Parts >>

Price: $46.95

Out of stock

Part Number: HM-CB100-Z-28-Version2 %RX2436%

Manufacturer: Walkera

Manufacturer Part No: HM-CB100-Z-28-Version2

Email this page to a friend

Brushless Receiver for Walkera CB100 with the latest new tail ESC HM-CB100-Z-27-VER 2. You can upgrade to this receiver but you must upgrade your tail ESC to http://www.wowhobbies.com/hm-43b-z-38tailspeedcontrollerescfor4343a43b-replacementparthm-4g3-z-43-1-1.aspx

Tech note: This receiver must be installed with the correct orientation, it must be lay down flat (not standing up like the RX2406B/C on the helicopter. Failure to install the receiver in the correct orientation will definitely cause the gyro to malfunction. Also the tail signal connector on this receiver must be connected with an ESC that has 2 plugs instead of 3, one of the plugs has a 3 wire signal/power connector, ground,+5v and signal. goto
http://www.wowhobbies.com/hm-43b-z-38tailspeedcontrollerescfor4343a43b-replacementparthm-4g3-z-43-1-1.aspx

Important installation instruction !!!!!!!

The orientation of this receiver should lay be lay down flat on the CB100 frame instead of standing vertical like on the old RX2406C receiver. If the orientation is installed incorrectly on the frame, the tail gyro will not function properly and the helicopter will spin out of control.