| | |
|
| |
| | |
|
|
Home > WOW DEALS > CX-AE-GY240 CopterX Heading Hold Gyro: This is not a Futaba GY240 gyro but it is directly compatible with it.
CX-AE-GY240 CopterX Heading Hold Gyro: This is not a Futaba GY240 gyro but it is directly compatible with it.
|
|
Part Number: CX-AE-GY240-GYRO
Manufacturer: CopterX
Manufacturer Part No: CX-AE-GY240-GYRO
|
This gyro has received raving review and it has been modified by Wow Hobbies. It will give your heli a better tail hold than the stock CopterX gyro at max punch out at a fraction of the cost of a Futaba GY240 gyro. It is not a Futaba GY240 gyro but has very similar level of performance.
It is suitable for use on a TREX450/compatible or smaller helicopter such as the Walkera CB180Z-PRO & the 1#A helicopter. The GY240-WOW is a high performance, compact, and light weight Angular Vector Control System gyro developed specifically for model and micro helicopters.
Futaba is a registered trademark of Futaba Inc. Spektrum is registered trademark of Horizon Inc. JR is a registered trademark of JR Radio.
Specification and Instruction
DELAY adjustment: 0-100% (This is the adjustment of how much delay on the gyro action)
LIMIT gyro gain adjustment: 0-100% This adjustment can also be made on the radio if it is a programmable TX.
DS: on/off switch for digital or analog servo. Switch to DS if you are using a digital tail servo.
DIR: REV or NOR switch to change servo direction so the tail pitch is moving in the correct direction.
Gyro must be installed between the tail servo and the receiver. Follow instruction on your Tx for the proper setup.
(No manual is included, please follow the instruction above)
Dimension: 1 inch x 1 inch x 0.8 inch (25.6 mm x 25.6 mm x 20.6mm height)
Weight: 14.2g with case on.
Weight: 3g without case and wires. |
|
|